Tutorial: Cup holders

Since I haven't done much knitting this week, I thought I would give you some ideas. If you have been knitting socks as long as I have, you end up with socks that have holes in them. Even if you darn them, eventually the sock fabric is so thin that you have to either re-knit the thin part or toss it out. But there are usually other parts that are in perfect shape and it is a waste to throw the whole sock out. Today, we will reincarnate sock legs into cup holders. They make quick gifts and you can make one to fit every cup you will ever use and keep them in your purse, your backpack, your tote, your car, etc. Each pair of socks makes at least 2 cup holders.
Here is one of my dearly-beloved socks. The sole is really worn thin.
I snipped a thread right where the heel began. This is where the thin part is. My socks wear at the heel and the ball of the foot. Then I unraveled a row of sts. This is a top-down sock so unraveling is easy. If it is knit toe-up, wait for the next tutorial because the sock won't unravel properly in this direction. Here you can see where I cut and separated the good part from the worn part.
Next, measure your cup and mark that distance on your sock leg, starting at the cuff. Unravel the yarn to about 1" shorter than that mark. Wind up your yarn into a small ball so you have it to knit from. If you can't do this, or your sock leg is too short, find some yarn of a similar weight that will look good with your sock and use it.

Now knit 1" of ribbing in either your unraveled yarn or the matching yarn. Don't worry about kinks in the unraveled yarn. They will go away when you wash the cup holder. Bind off loosely in rib and ta-da! you have a cup holder. Here is the pair I made from those socks. They fit a Starbucks Grande and a Venti cup.
If you don't have worn out socks, do not despair. Just take some left over sock yarn and knit yourself a sock leg without a foot and you have a cup holder.

It is a matter of preference whether you like the cup holder to cover the entire cup (as above) or leave some space at the top and bottom (as below). The lid will cover the lip of the cup but sometimes I like to take the lid off and drink. If you are like me, you will prefer the holder to be slightly smaller than the cup. The cup holder below fits a number of different cup sizes.You can practice a new stitch pattern (as I did) or make it plain with some ribbing. Your cup holder will keep the drink warm (or cold) and prevent condensation with cold drinks.

You can also make ones that fit your water bottle to keep the condensation from dripping onto things.

Use your new eco-friendly (recycle, reuse) cup holder and water bottle cover in good health!